Filter
Top Products
*
T˚
T˚
T˚
27° 27°
SEA-TOUCH
9/12
145_ENwww.tissot.ch
THERMOMETER
Activate glass
Thermometer display
1 sec.
DIVE > MANUAL START & STOP
1 sec.
5 sec.
Activate glass
(outside of water)
LCD check - hands in
zero position for depth
and dive speed
Dive display Start Dive manually
Dive mode active - elapsed time
in LCD, minutes hand shows
depth in meters or feet on bezel,
hours hand shows dive speed
in m/min or ft/min on dial
1 sec.
Only above depth limit 1m40:
- Short pressure on center
push-button after short dive
below 3 minutes.
- Long pressure on center
push-button after long dive
over 3 minutes.
Stop
Start
Description of function
In thermometer mode, your SEA-TOUCH
displays the ambient temperature.
Explanations
The temperature displayed corresponds to
that of the watch case, so this temperature
is influenced by your body temperature. That
is why the temperature displayed may differ
from the ambient temperature.
To display the actual ambient temperature,
the watch needs to be taken off for 15 to
30 minutes, in order to be free from the influence of body temperature.
Under water the thermometer will show you the water temperature. The
body temperature will not influence this measure. However the watch will
need a few minutes to adapt from the air temperature to the water tempera-
ture when going into the water.
Characteristics of function
The temperature can be displayed in degrees Celsius [°C] or degrees Fahren-
heit [°F]. (See procedure to follow for changing units on page 5).
Conversion formulae: T
0
C = (T
0
F – 32) x 5/9
T
0
F = T
0
C x 9/5 + 32
Measurement range: – 5°C to + 55°C / 23°F to 130°F
Accuracy: ± 1°C / ± 1.8°F
Resolution: 1°C / 1°F
GLOSSARY > THERMOMETER