Filter
Top Products
13
Recall Mode
Chrono Recall allows you to review stored lap information while the Chrono
is running or stopped.
A.In Recall mode, press STOP repeatedly to display, in order, Average
Speed, Average Pace, Distance and Lap and Split times for the first lap.
Lap time appears in upper line of display. The lap number display has an
R in front of it to indicate recall. Continue to press STOP to display
information for successive laps until the final lap. Press START to go
back to previous display.
B.If no speed and data information was recorded for a lap, then only the
lap time (in upper line of display) and split time are displayed.
C.Press MODE button at any time to return to Time mode.
D.To rapidly scroll through multiple laps, press and hold STOP or START.
Split or Lap Timing
Note. The Display can show either
Lap or Split time. Press STOP with
chrono reset to choose lap or split
display.
A. Press START to begin timing.
During the timing of a lap, the
upper part of the display can show
speed and distance data if the
Transceiver is operating.
B. Press SPLIT to store LAP and SPLIT. The main display freezes while the
watch continues timing the next segment. After 10 seconds the Lap or
Split time is again shown in the main display. If the watch is set to show
speed or pace, then the average value for the current lap is displayed
during the hold period and AV appears in the display.
C. Press SPLIT again to store another lap. With the 50-Lap model, if you
take more than 50 laps the watch will display the lap count up to 99 laps
and store information from the last 50 laps to the watch’s memory.
D. At any time, press SPEED/DISTANCE DISPLAY to cycle though time and
distance information that is displayed in upper line during timing.
E. Press STOP to end timing. The display will show either final lap time or
final event time.
12