Filter
Top Products
INDIGLO
®
NIGHT-LIGHT / NIGHT-MODE
®
FEATURE
1. Press INDIGLO® button to activate night-light. INDIGLO®
technology illuminates entire watch face at night and in
low light conditions.
2. Continue to press up to 3 seconds to maintain illumina-
tion.
3. Press and hold INDIGLO® button for 4 seconds to
activate NIGHT-MODE® feature.
4. When NIGHT-MODE® feature is activated, push any
button to illuminate watch face for 3 seconds.
5. To deactivate NIGHT-MODE® feature, press INDIGLO®
button for 4 seconds. Feature will automatically
deactivate.
W
WATER & SHOCK RESISTANCE
If your watch is water-resistant, meter marking or (O) is
indicated.
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT
PRESS ANY BUTTONS UNDER WATER.
1. Watch is water-resistant only as long as lens, push
buttons and case remain intact.
2. Watch is not a diver watch and should not be used for
diving.
3. Rinse watch with fresh water after exposure to salt
water.
4. Shock-resistance will be indicated on watch face or case-
15
ALARM
Up to three alarms may be set to remind you of upcoming
events.
1. Press MODE until ALARM appears.
2. Press START/SPLIT to select alarm 1, 2, or 3.
3. Press SET to set selected alarm.
4. Hour digits flash. Press + / – to change hour.
5. Press NEXT and + / – to set minutes, AM or PM (if
primary time display is in 12-hour format), DAILY, WEEK-
DAYS, WEEKENDS, or day of the week (weekly alarm).
6. Press DONE to confirm and exit.
7. Press STOP/RESET to turn Alarm ON or OFF.
TIPS:
• When Alarm is on,
d appears in Time display.
• When Alarm sounds, INDIGLO® night-light and alarm icon
flash and alert sounds. Press any button to silence.
• If no button is pushed, alert will cease after 20 seconds
and Backup Alarm will activate after 5 minutes.
POD INFORMATIONAL AND ERROR MESSAGES
Blinking antenna icon
v – The watch is currently searching
for the POD when the wave is blinking. Make sure the POD
is on and within range of the watch.
Steady antenna icon
V– The watch and the POD are com-
municating
Steady jogger icon
o – There is no movement detected
Moving jogger icon
n– Movement has been detected by the
POD and the data is being transmitted to the watch
NO POD DATA – The POD signal was lost. Make sure the
POD is powered on and within range.The watch automati-
cally powers off after 16 hours of continuous use.At that
point, the watch receiver must be turned on again by
pressing ON/OFF.
14
Water-Resistance Depth p.s.i.a.* Water Pressure
Below Surface
30m/98ft 60
50m/164ft 86
100m/328ft 160
T0801-21_W243_NA.qxd 2/29/08 11:54 AM Page 14