Filter
Top Products
FCC Notice (U.S.) / IC Notice (Canada):
This device complies with part 15 of the FCC Rules.Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference,and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device,pursuant to part 15 of the
FCC Rules.These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions,may cause harmful interference to radio communi-
cations.However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme
NMB-003 du Canada.
17
back. Watches are designed to pass ISO test for shock-
resistance. However, care should be taken to avoid
damaging crystal/lens.
BATTERIES
CHANGING THE WATCH BATTERY
1. Using a coin, insert the coin into the slot on the battery
hatch.
2. Unscrew the battery hatch by turning the coin counter-
clockwise.
3. Remove plastic frame covering battery.
4. Remove battery from watch.
5. Peel off mylar sticker from old battery and place on new
battery.
6. Insert new battery into watch case.
7. Replace plastic frame covering battery.
8. Replace battery hatch.
9. Using a coin, turn the battery hatch clockwise to close.
DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE.
KEEP LOOSE BATTERIES AWAY FROM CHILDREN.
CHANGING THE POD BATTERY
1. Simultaneously push the button on the case back and
slide the cover away from the POD.
2. Remove the old battery and insert a new CR2032 battery
into the battery compartment.
3. Reinstall the battery hatch.
16
T0801-21_W243_NA.qxd 2/29/08 11:54 AM Page 16