Filter
Top Products
12
STAR
TRAC
S
-
TBT
X
TOTAL
BODY
TRAINER
O
WNER
’
S
M
ANUAL
Gently push the display cables down into the neck, and slide the
display into the base. Be sure the display is fully seated. Secure
the display to the base with four ___________ bolts and _________
flat washers. Use two screws in the front side of the neck, and two
in the rear side. Tighten the screws securely.
3. Install the Upper Body Arms
NOTE: Take care not to install the upper body arms backwards. Be
sure the arms are positioned as shown when installed.
Place on upper body arm on the right-side hub. Be sure the pin in
the arm bracket engages the unthreaded hole on the hub. Secure
the upper body arm to the hub with four _________ bolts and
_________ lock washers. Tighten the bolts securely.
Repeat for the left-side upper body arm.
4. Install the End Caps
NOTE: Be sure the holes in each end cap face the rear of the unit.
Separate the halves of the right -side end cap. Place the end cap halve
around the hub. Use a piece of tape to temporarily hold the end cap
halves together.
Secure the end cap halves together with four _________ Phillips head
screws. Tighten the screws firmly.
Repeat for the left-side end cap.
5. Final Assembly
Be sure all bolt and screws are tightened securely.
If needed, use the leveling adjusters at the rear of the base to level
the unit. Loosen the lock nuts on the adjusters. Rotate the
adjusters until the unit is stabilized, then retighten the lock nuts.
You have now completed assembly of your STAR TRAC S-TBTx
TOTAL BODY TRAINER.
Step 3
Step 4
Step 2b
Step 5