Filter
Top Products
STAR
TRAC
S
-
TBT
X
TOTAL
BODY
TRAINER
O
WNER
’
S
M
ANUAL
11
ASSEMBLY AND SETUP
UNPACKING
NOTE: Do not remove the base from the shipping carton at this time.
Remove the top cover from the shipping carton. Remove all parts and shipping supports (except the base) from the carton, and
verify that the following parts are included in your shipment:
Description Qty
Base 1
Display 1
Upper Body Arms 2
End Caps 2
Bolt, Allen Head, __________ 4
Description Qty
Bolt, Hex Head, __________ 8
Screw, Phillips Head, ___________ 8
Flat Washer, ___________ 4
Lock Washer, ___________ 8
TOOLS REQUIRED
Your STAR TRAC S-TBTx TOTAL BODY TRAINER can be assembled using the following tools:
n Metric Hex Key Wrenches
n Metric Open-End Wrenches
n Metric Ratchet Socket Wrench Set
n Torque Wrench
n Channel Lock Pliers
n Vice Grip Pliers
n Rubber Mallet
n Phillips Head Screwdriver
Your STAR TRAC S-TBTx TOTAL BODY TRAINER includes a hex key set and combination open-end wrench.
ASSEMBLY
1. Unpack and Position the Base
CAUTION: The rear end of the base is very heavy. Two persons are
needed to lift this end when moving the base.
Cut the long edge of the shipping carton base at both ends. Fold
the flap down to make a ramp.
With the aid of a helper, lift the rear end of the base, and roll the
base off of the shipping carton platform. Place the base on the floor
in the location where the unit will be used. Be sure the chosen
location is level.
2. Install the Display
NOTE: You will need someone to assist you to install the display.
Have the person who is assisting you hold the display while you
route the display cables and connect the neck.
Have your helper hold the display close the neck on the base. Plug
the display power and I/O cables from the base into the mating
display connectors.
Once display power and I/O cables are connected, route the coaxial
cable up the full length of the display neck before seating the
display unit on the base.
NOTE: The round coaxial cable is not used.
Step 1
Step 2a