Filter
Top Products
STAR TRAC TOTAL BODY TRAINER OWNER’S MANUAL 25
After using your
STAR TRAC TOTAL BODY TRAINER
for a period of time, you may wish to change some of its settings.
MANAGER MODE
The Manager Mode allow you to query and modify the basic settings of your TOTAL BODY TRAINER. To enter Manager Mode:
1. Press and hold the
,
and keys together.
2. A beep will sound and “MANAGER MODE” will display momentarily in the Message Window.
3. Release all keys. “SERIAL NO #####” will display in the Message Window.
NOTE: The system will automatically exit Manager Mode if no key is pressed for 30 seconds.
The following keys are used to modify settings in MANAGER MODE:
Upper and Lower Data Information Window S
CROLL Keys: Display the next and previous parameters, respec-
tively.
Increase and Decrease L
EVEL Keys: Adjust the value of the displayed parameter up and down, respectively, in incre-
ments of 1 unit . These keys do not save the new value - see OK Key below.
OK Key: Updates (saves) the values of all parameters in Flash memory, and exits Manager Mode.
NOTE: To exit Manager Mode without saving any values or settings, press the Q
UICK START key.
The items that you may display and change with the previous keys are:
MAINTENANCE MODE
Your Service Representative may need to check accumulated data about the past usage of your
STAR TRAC TOTAL BODY TRAINER
, test its
display controls, or investigate error messages. For these reasons, your TOTAL BODY TRAINER is equipped with a Maintenance Mode. The
Maintenance Mode includes all of the items available through Manager Mode, plus additional items for Service and Diagnostic use. To
enter Maintenance Mode:
1. Press and hold the
,
and keys together.
2. A beep will sound and “MAINTENANCE MODE” will display momentarily in the Message Window.
3. Release all keys. “SERIAL NO #####” will display in the Message Window.
MANAGER / MAINTENANCE MODE
Lowest Highest Default
Item Value Value Value Meaning
Serial No 0 65535 0 Serial number (set by factory)
Date 01/00 12/99 01/05 Manufacture date for the TOTAL BODY TRAINER (set by factory)
Display Vers 1 01.00 99.99 N/A Display panel software version (set by factory)
Display Vers 2 01.00 99.99 N/A Display panel software version (set by factory)
LCB Vers 01.00 99.99 N/A Display panel software version (set by factory)
Units English Metric English English = units of pounds, miles, feet, inches;
Metric = units of kilograms, kilometers, centimeters.
Time 5 99 99 Maximum time in minutes allowed for program, excluding warm-up and cool-down.
Weight 50 (Lb) 350 (Lb) 350 lbs Default (to user), typical weight in lb (UNITS=English), or kg
22 (KG) 158 (KG) 158 (KG) (UNITS=Metric).
Language N/A N/A ENGL Language is English (ENGL), Dutch (DUTC), French (FREN), German (GERM),
Portuguese (PORT), Spanish (SPAN), Swedish (SWED), Italian (ITAL) or Katakana
(KATA).