Filter
Top Products
TREADCLIMBER by STAR TRAC - OWNER’S MANUAL | Operating Instructions
33
DISPLAY CONTROL PANEL FEATURES
Your TreadClimber is equipped to provide you and your users unlimited exercise opportunities. Experiment with its
features to find the right combination for your fitness regimen. The Display panel shown on the following provides
the operating controls and display elements described in the following:
QUICK START Key: Starts your TreadClimber moving using a default weight of 155 lbs / 70 kg and a
time limit of 99 minutes. QUICK START will allow you to manually operate the unit. The QUICK START
key also
serves as an “Enter” key in programming modes.
STOP Key: Pauses your workout when pressed once. Ends your workout when pressed twice.
Graphic Display: Traces your progress
through each of the programs and allows you
to anticipate changes in terrain. Display
elements illuminate from left to right across
the bottom of the display to indicate your
progress through the course. At each step,
display elements illuminate in columns to
indicate your ascent up the gradient that is in
effect.
Speed Keys: During Program setup, press the or keys, respectively, until the desired
speed appears in the Information Window, then, press START or key. During a Program, press
the or keys, respectively, to increase or decrease belt speed in 0.1 miles per hour (mph)
or 0.1 kilometers per hour (km/h) increments. Speed cannot be higher than the established
“MAXIMUM SPEED” parameter. These keys repeat when pressed and held.
Speed Window: Shows the speed at which the user is walking/running.
Incline Level Keys: Adjust the amount of up and down movement of the treadles from 1 (minimum) to 5
(Maximum). These keys repeat when pressed and held.
Incline Level Window: Shows the incline level from 1 to 5.
Numeric Keypad: Allow you to enter specific values for program parameters during program setup.
The numeric keypad can also be used to adjust TreadClimber
®
speed while the TreadClimber is
operating.
OK Key: Selects/Enters values and programs during set-up.
Time Window: Shows the total time you have walked so far.
Distance Window: Shows the total number of miles or kilometers you have walked thus far.