Filter
Top Products
STAR TRAC E SERIES TOTAL BODY TRAINERS OWNER’S MANUAL
11
ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC E SERIES TOTAL BODY TRAINER.
TOOLS REQUIRED
■ Hex (Allen) Key, 3/16-inch
■ Hex (Allen) Key, 5 mm
■ Screwdriver, Phillips #2
UNPACKING AND ASSEMBLY
1. Unpack the Shipping Carton
Remove the top and sides of the shipping carton.
Remove the display box and upper body arms and set aside
Remove the remaining foam packing inserts and the protective bagging from the
Total Body Trainer.
2. Install the Display
Take the 3 cables that are coming out of the lower neck and feed them through the
upper neck through the hole provided. Make sure you hold the cables as you insert
the upper neck into the lower neck.
After inserting the neck, make sure the cables are not pinched between the 2 sec-
tions of the neck.
Install (2) 5/16-18 x 3/4” Button Head Screws into the front of the neck, use a 3/16
hex key to tighten the screws to 200 lb-in (23 N-m) of torque..
Secure the neck by tightening the 3/8-16 x 2” Socket Head Cap Screw using a
5/16” hex key. Tighten bolt to 300 lb-in (34 N-m).
Bolt