Filter
Top Products
(e) Position the lower end of the left handrail over the rear leg weldment, then pulling the
handrail towards you secure it into position with 2 washers and 2
hex screws provided using
a 5/32” (4mm) hex key or T-handle.
(f) Tighten the button head screws from step d above.
(g) Repeat steps c - f for the right handrail.
(h) Replace the 2 leg levelers that were removed in step b.
(i) Return the STAR TRAC E-ST STEPPER to the upright position.
6. Final Assembly and Testing
Check all screws to ensure they are tightened securely.
Adjust leveling feet to assure that the Stepper is level to the floor and does not rock back and forth.
Make sure the side handrails are tight.
Mount the Stepper, begin stepping, and verify that the display panel turns on.
Operate the unit to check for proper operation.
You have now completed assembly of your STAR TRAC E-ST STEPPER.
14 STAR TRAC E-ST STEPPER OWNER’S MANUAL