Filter
Top Products
Page 5 SPINNER
®
OWNER’S GUIDE
ASSEMBLY AND SETUP _
ASSEMBLY AND SETUP
SPINNER
®
V ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your SPINNER
®
V.
UNPACKING
Position the shipping carton so the “Heavy End” logo is located at the bottom. Open the top of the carton and fold back all four
flaps. Carefully tilt the box forward so that the box may be lifted to expose the bike. Remove all parts from the shipping carton
and foam inserts, and verify that the following parts are included in your shipment:
V-bike Parts List
Description Qty. Description Qty.
Main Frame Assembly (not shown) 1 Tension Handles w/Washers 2
Handlebar 1 Tension Handles w/o Washers 2
Seat 1 Water Bottle Brackets 2
Handlebar Post 1 8mm x 70mm (long) w/Washer and Nuts 2
Seat Post 1 8mm x 60mm (short) w/o Washer and Nuts 2
Back Leg 1 Allen Wrenches, Metric 2
Front Leg 1 Multi-Purpose Wrench 1
Leveling Adjusters (pre-installed) 4
Pedals (set of two) 1
Spare Parts Kit (includes brake pad and pedal straps) 1
Spare Parts Kit- Save the box of spare parts in a safe place so you have service parts when needed in the future.
Take time now to enter your Spinner
®
V serial number in the space below (serial number is located on the bottom cross
member). If parts are missing, or if you have any operational questions, please call Star Trac’s Service department at (800) 503-
1221; have your serial number ready.
Serial No._____________________________________________
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been overlooked.
If parts are missing, or if you have any product questions, please call Star Trac’s Service Department at (800) 503-1221, please have your Spinner’s
serial number ready.
CAUTION: Damage to the bike during assembly is not covered as part of the limited Star Trac® warranty. Take care not to drop or lean the bike on
the handle bar pop-pin. Carefully stand the bike up in the normal upright position on a stable surface so it will not tip over during assembly.