ASSEMBLY INSTRUCTIONS
R
8
STEP 7
There is a "R" decal on the RIGHT HANDLEBAR(7) and RIGHT LINKAGE(74). Refer to above illustration.
Press a LINKAGE BUSHING(42) into the RIGHT LINKAGE(74). Attach the RIGHT LINKAGE(74) onto the
bottom end of LOWER BAR(8) with HEX HEAD BOLT(M8x1,25x45mm)(61), WASHER
(M8xø22mmx1.5mm)(68), ARC WASHER(M8)(71), and NYLOCK NUT(M8x1.25)(62).
STEP 8
Attach the right LOWER BAR ASSEMBLY(8) to the RIGHT HANDLEBAR(7) with ROUND HEAD BOLTS
(M6x1x12mm)(59) and ARC WASHERS(M6)(70). Repeat STEP 7 and STEP 8 to assemble the LEFT
HANDLEBAR(6).
STEP 9
Slide the AXLE(36) through BUSHINGS(37) into the MAIN FRAME(1). Slide the two BUSHING WASHERS
(38) onto both sides of the AXLE(36). Slide the LEFT and RIGHT HANDLEBARS(6, 7), with the GRIPS
facing outside, onto AXLE(36) and fasten with LARGE WASHERS(M8)(39) and NYLOCK NUTS(M8x1.25)
(62). Place a NUT CAP(40) onto the NYLOCK NUT(M8x1.25)(62) on both sides.
STEP 10
Slide the two FOAM GRIPS(41) onto the LEFT and RIGHT HANDLEBARS(6, 7).
NOTE:
R
Lubricate the LEFT and RIGHT HANDLEBARS(6, 7) with a small amount of liquid soap for easier
installation of the FOAM GRIPS(41).
L
L