Filter
Top Products
ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at: parts@staminaproducts.com
6
The bracket needs to
point toward the footrest.
The bracket
needs to
point
toward
the footrest.
STEP 1
Unfold the BASE ASSEMBLY to an upright position by moving the FRONT FRAME(1) away from REAR
FRAME(2). Then push down on the middle of the two FOLDING LINKAGES(3) until they are fully
locked down.
STEP 2
There is a "L" decal on the LEFT PIVOT ARM(5), and a "R" decal on the RIGHT PIVOT ARM(6).
Slide the bottom of the LEFT and RIGHT PIVOT ARMS(5, 6) into the brackets located at each side of the
MAIN FRAME(4). Align the hole on the arm with the peg on the bracket, and insert the peg into the hole
to lock the
PIVOT ARMS(5, 6) in position. Then secure the PIVOT ARMS(5, 6) on the pegs with
ROUND HEAD BOLTS(M6 x 10mm)(54) and LARGE WASHERS(M6)(53).
STEP 3
Attach the MAIN FRAME(4) onto the REAR FRAME(2) by sliding the slots in the ends of the PIVOT
ARMS(5, 6) into the slots on the REAR FRAME(2). Secure the PIVOT ARMS(5, 6) in the slots by
screwing the
BOLTS(M8 x 15mm)(45), WASHERS(M8)(51), LARGE WASHERS(M8)(52), and
NYLOCK NUTS(M8)(49) onto the brackets on the REAR FRAME(2).
R
L