Filter
Top Products
ASSEMBLY INSTRUCTIONS
8
STEP 4
Connect the SUPPORT ARM(44) to the RIGHT PIVOTING ARM(8) with BUTTON HEAD BOLT
(M8x85mm)(83) and NYLOCK NUT(M8)(73).
STEP 5
Refer to the inset drawing. Remove the LOCKING KNOB(56) from the LINKAGE CONNECTOR(54).
Then swing the LINKAGE(9) toward the front. Insert the the LINKAGE CONNECTOR(54) through the
CONNECTOR(53) and secure with the LOCKING KNOB(56). Press the CRANK CAP(11) into the
hole on the
PEDAL RAIL(37).
STEP 6
Attach the PEDAL RAIL(37) to the RIGHT RAIL CONNECTOR(61) with BUTTON HEAD BOLT
(M10 x 85mm)(91), WASHER(M10)(68), and NYLOCK NUT(M10)(70).
Repeat the above steps on the left side.
(61) RIGHT RAIL CONNECTOR
The rectangular part points to
the rear.