Filter
Top Products
ASSEMBLY INSTRUCTIONS
7
STEP 3
Slide the UPRIGHT SLEEVE(15) onto the UPRIGHT(4). Slide the TENSION CABLE(26) into the
bottom end of the
UPRIGHT(4). Pull the end of the TENSION CABLE(26) through the square hole in
the
UPRIGHT(4). CAUTION: Be careful not to damage the CONNECTION WIRE(30). Connect the
CONNECTION WIRE(30) to the SENSOR WIRE(29). Insert the UPRIGHT(4) into the MAIN
FRAME(1) and secure with HEX BOLTS(M8 x 20mm)(87), LOCK WASHER(M8)(69), HEX
BOLTS(M8 x 50mm)(86), and NYLOCK NUTS(M8)(73). Slide the UPRIGHT SLEEVE(15) down to
cover the bolts on the
UPRIGHT(4).