Filter
Top Products
SET UP INSTRUCTIONS
10
Adjust the LEVELING CAPS(44) on the REAR STABILIZER(3) so that the SpaceMate
E100 sets on the floor without rocking.
Adjust the STAND(46) on the FRONT STABILIZER(2) so that the stand touches the
equipment mat or floor. Refer to the inset drawing.
LEVELING:
MOVING:
Locate and read the WARNING LABEL(74) on the SpaceMate
E100. Make sure that all
users read the WARNING LABEL(74).
CAUTION:
FUNCTION INSPECTION:
Visually inspect the SpaceMate E100 to verify that assembly is as shown in the above illustration. Check
the function of the SpaceMate
E100. Stand on the foot pedals and place your hands at a comfortable
position on the handrail. Slowly move your highest foot forward and follow the natural path of the machine.
Turn the crank slowly through one complete revolution to verify that the drive train functions properly. Adjust
the TENSION KNOB(21) and verify that it functions properly.
Place the SpaceMate E100 in the area where it will be used. It is recommended that the SpaceMate
E100 be placed on an equipment mat. The SpaceMate E100 is approximately 31 5/8" long x 15 3/8" wide
x 49 3/8" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 5.5 feet long is required for
safe operation of the SpaceMate E100. Make sure that adequate space is available for access to and
passage around the SpaceMate
E100.
Grasp the HANDRAIL(71) and REAR STABILIZER(3) to move the SpaceMate
E100, two
people are required for moving. Do not use the Pedal Arms to move the SpaceMate
E100.
The Pedal Arms will move and may pinch your hand or fingers.
1.
2.
Equipment Mat