Filter
Top Products
STORAGE
Store the AeroPilates Pro XP556 in a clean, dry place.
It is recommended that two people be available to move the AeroPilates
Pro XP556.
To move the AeroPilates
Pro XP556: First, attach one of the TENSION CORDS(29) in the slot on
the CORD HOLDER(21) to prevent the CARRIAGE(25) from moving. Second, grasp the PULLEY
POST(36) and lift the unit from the back. Third, roll the AeroPilates
Pro XP556 on the moving wheels
that are attached to the FRONT LEG(2).
1.
2.
3.
MAINTENANCE
The safety and integrity designed into the AeroPilates Pro XP556 can only be maintained when the
AeroPilates
Pro XP556 is regularly examined for damage and wear. Special attention should be given to
the following:
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components should be replaced immediately or the AeroPilates
Pro XP556 removed
from service until repair is made.
Verify that the Warning Label is present and legible. Replace the Warning Label if it is missing or
damaged.
Verify that the ROPES(41) are properly installed on the PULLEY SETS(38).
Check the condition of the ROPES(41) and replace if they are frayed or worn.
Check the PLASTIC SNAP HOOKS(42) on the ends of the ROPES(41). Replace the ROPES(41) if
PLASTIC SNAP HOOKS(42) are damaged or deformed.
Check the TENSION CORDS(29). If a TENSION CORD(29) is stretched and loose, re-tie the knot on
the end of the cord. Replace TENSION CORDS(29) that are frayed or worn.
Check the BUNGEE CORD(48) on the CARDIO REBOUNDER(46) for wear. Replace the CARDIO
REBOUNDER(46) if the BUNGEE CORD(48) is frayed or worn.
Check the PULLEY SETS(38) for excessive wear. Replace worn PULLEY SETS(38).
Check the HAND STRAPS(43) for damage. Replace damaged parts.
Check the FOAM SLEEVE(18) and FOAM PADS(34) and replace if damaged or worn.
Check the STOP PLATES(22, 23) for looseness or damage and replace any damaged parts.
Check the CUSHION(28) and replace if it is damaged or worn.
Check and clean the ROLLERS(26) and the rolling surfaces on the rails. Clean by wiping with a dry
cloth.
Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates
Pro
XP556.
Keep your AeroPilates
Pro XP556 clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
12