Filter
Top Products
10
ROPE LENGTH ADJUSTMENT
The ROPES(41) feed through the PULLEY SETS(38) then thread through the loops on the underside of
both outer edges of the CARRIAGE(25). PLASTIC SNAP HOOKS(42) on the end of each rope are used to
adjust the ROPE(41) length. If more length is needed, attach the PLASTIC SNAP HOOKS(42) to loop D. To
shorten, bring the ROPES(41) around the last loop D and secure to loops A, B, or C with the PLASTIC
SNAP HOOKS(42). Wrap ROPES(41) through the loops and attach where needed to shorten ROPES(41)
even more.
B
D
C
A
OPERATIONAL INSTRUCTION
LOAD ADJUSTMENT
The resistance of the CARRIAGE(25) can be adjusted by securing the TENSION CORDS(29) in the slots
on the CORD HOLDER(21). You can achieve various levels of resistance by securing different numbers of
the TENSION CORDS(29) in the slots.
NOTE:
Over time your TENSION CORDS(29) will relax. To increase resistance in the TENSION CORDS(29),
stretch and re-tie the tension cords in a more taut position.