Filter
Top Products
Place the AVARI® Conversion II Rower Recumbent Bike in the area where it will be used. It is
recommended that the AVARI® Conversion II Rower Recumbent Bike be placed on an equipment
mat. The AVARI® Conversion II Rower Recumbent Bike is approximately 77 inches long x 23 inches
wide x 33.5 inches tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 8.5 feet
long is required for safe operation of the AVARI® Conversion II Rower Recumbent Bike. Make sure
that adequate space is available for access to and passage around the AVARI® Conversion II Rower
Recumbent Bike.
LEVELING: Adjust the location of AVARI® Conversion II Rower Recumbent Bike so the bike sits on
the oor without rocking.
MOVING: The AVARI® Conversion II Rower Recumbent Bike has a pair of MOVING WHEELS(76)
on the FRONT STABILIZER(2). Grasp the RAIL CAP(55) to move the AVARI® Conversion
II Rower Recumbent Bike.
FUNCTION INSPECTION:
Visually inspect the AVARI® Conversion II Rower Recumbent Bike to verify that assembly is as shown
in the above illustration. Check the function of the AVARI® Conversion II Rower Recumbent Bike by
turning the crank slowly through one complete revolution to verify that the drive train functions properly.
Adjust the TENSION KNOB(27) and verify that it functions properly.
CAUTION: Locate and read the CAUTION LABEL(115) on the AVARI® Conversion II Rower
Recumbent Bike. Make sure that all users read the CAUTION LABEL(115) before using the
product.
SET UP INSTRUCTIONS
12
Equipment Mat
(not included)