Filter
Top Products
ASSEMBLY INSTRUCTIONS
11
STEP 13
Insert the SENSOR WIRE(29) and PULSE CONNECTION WIRE(75) into the bottom end of METER
POST(31) and pull them out of the top of the METER POST(31). Pull the HANDLEBAR(25), twist the
STRAP(21) and slide the strap thru the gap into the hole in the bottom of the METER POST(31). Slide the
METER POST(31) onto the MAIN FRAME(1) and secure with SCREW(M5x18mm)(84).
STEP 14
Install two AA batteries into the METER(30), the batteries are not included. See page 13 for detailed
battery installation instructions. Plug the SENSOR WIRE(29) and PULSE CONNECTION WIRE(75) into
the METER(30) and push the excess wires back into the METER POST(31). Place the METER(30) on the
plate on the METER POST(31), then slide it down to lock in position.
NOTE: Please be careful not to damage the Sensor Wires when attaching the METER(30).
Gap