Filter
Top Products
STORAGE
14
FOLDING THE INVERSION TABLE
The INVERSION TABLE can be easily folded for storage.
To fold the INVERSION TABLE loosen the LOCKING KNOB(17) and pull out the LARGE SPRING
PIN(16). Now, slide the HEIGHT ADJUSTMENT BEAM(6) all the way up into the MAIN FRAME(4) until
the ADJUSTABLE INSTEP FRAME(7) is just below the MAIN FRAME(4), release the LARGE SPRING
PIN(16) and slide the HEIGHT ADJUSTMENT BEAM(6) slightly up or down until the spring pin locks the
beam in place. Remove the MAIN FRAME ASSEMBLY from the BASE by lifting up on the MAIN FRAME(4)
until the PIVOT ARMS(5) come out of the slots located at the top of the REAR FRAME(2), (Make sure the
NYLON STRAP is not attached to the MAIN FRAME(4) before attempting to remove it.) Push up on the
center of the FOLDING LINKAGES(3) and push the FRONT FRAME(1) and REAR FRAME(2) together
until they meet.
The safety level of the INVERSION TABLE can be maintained only if it is examined regularly for damage
and wear.
Check the warning label, nylon strap, strap buckle, pivot arms, nylon bed, Foam Pads, heel holders,
small spring pin and large spring pin for damage and wear.
Replace damaged and worn components immediately and/or keep the equipment out of use until repairs
are completed.
1.
2.
MAINTENANCE