Filter
Top Products
ASSEMBLY INSTRUCTIONS
10
STEP 7
Slide a FOAM PAD(21) onto a PAD TUBE(19) and press a SECURING PLUG(22) into the end of the
PAD TUBE(19). Then insert the other end of the PAD TUBE(19) through one of the two holes in the
LEG EXTENSION(9). Slide another FOAM PAD(21) over the protruding end of the PAD TUBE(19) and
press a SECURING PLUG(22) into the end of the PAD TUBE(19). Repeat to assemble the second set of
FOAM PADS(21), inserting the PAD TUBE(19) through the other hole in the LEG EXTENSION(9).
STEP 8
Install the PAD SUPPORT ASSEMBLY(7) into the LEG EXTENSION(9) by pulling the SPRING PIN(24)
on the LEG EXTENSION(9) and inserting the PAD SUPPORT ASSEMBLY(7) as shown.
NOTE: The pin on the SPRING PIN(24) must be inserted into one of the adjustment holes in the PAD
SUPPORT(7).