Filter
Top Products
5
ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please call
our toll-free number for assistance 1 (800) 375-7520 or e-mail us at: parts@staminaproducts.com
1.
Warning
Label
Warning
Label
STEP 1
Place the trampoline on the floor with the threaded
connectors pointing up. Refer to illustration 1. The two
LEGS(6) with a Warning Label must be on opposite
sides of the INSTRIDE
trampoline. Screw one of
the LEGS(6) with a Warning Label onto a threaded
connector on the rail frame. Attach the other LEG(6)
with a Warning Label to the threaded connector
directly opposite the other LEG(6) with a Warning
Label. Screw the other four LEGS(6) onto the threaded
connectors on the rail frame.
STEP 2
Place the trampoline in the normal use position. Make sure that
the SAFETY PAD(5) covers the springs on the INSTRIDE
trampoline. Stand on the trampoline to make all six legs set flat on
the floor. Refer to illustration 2.
2.
CORRECT PLACEMENT OF
SAFETY PAD
STEP 3
Post the USE INSTRUCTIONS SIGN(11) in a highly visible and
safe location. The USE INSTRUCTIONS SIGN(11) shall be placed
such that it will be readily visible to the intended viewer.
The SAFETY PAD(5) must be securely attached
to the frame before using the trampoline. It must
be properly positioned as shown in illustration 2.
WARNING:
!
Threaded
Connector
Threaded Connector
NOTICE: It is possible that the INSTRIDE trampoline LEGS(6) will not have the inside threads needed to
screw it onto the rail frame as described in this manual. If this is the case, it could be due to one of two
reasons: (1.) the LEG CAP(7) was placed on the wrong end of the leg, or (2.) the LEG(6) doesn't have the
threads on either end.
If this is the case with any of your INSTRIDE trampoline LEGS(6), please
remove the LEG CAP(7) and check to see if this end is threaded. If so, simply
place the LEG CAP(7) on the other end and screw into the rail frame as described
in STEP 1. If not, please call our toll free number for assistance 1-800-375-7520
or email us at parts@staminaproducts.com.