Filter
Top Products
The safety and integrity designed into the BODYTRAC
TM
can only be maintained when the BODYTRAC
TM
is regularly examined for damage and wear. Special attention should be given to the following:
MAINTENANCE
LOAD ADJUSTMENT
The resistance of the shocks can be adjusted by twisting the adjustment
knob at the top of the shocks. There are settings from 1 to 12. Setting #1
will provide the lowest resistance. Setting #12 will provide the highest
resistance.
CAUTION: The shocks get HOT after a few minutes of use.
Adjustment
Knob
Mark
13
OPERATIONAL INSTRUCTIONS
Pull on the HANDLEBARS(17, 18) and verify that the SHOCK(22) provides tension.
Clean the roller tracks in the CENTER BEAM(1) with an absorbent cloth.
Verify that the WARNING LABEL(67) is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement WARNING LABEL(67) if it is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the BODYTRAC
TM
removed from service
until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the BODYTRAC
TM
.
Keep your BODYTRAC
TM
clean by wiping it off with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.