Filter
Top Products
ASSEMBLY INSTRUCTIONS
7
STEP 1
Remove your AeroPilates Performer 270 from its packaging, placing the product on its side with the
LOCKING PIN(26) side upward. Remove the LOCKING PIN(26) and unfold the MAIN FRAME ASSEMBLY
separating the half that has the attached LOCKING PIN(26). When completed, the frame should form a "V"
with the frame ends separated approximately three feet.
STEP 2
Attach the four RUBBER FEET(25) to the FRONT FRAME(1) and REAR FRAME(2) with ROUND HEAD
SCREWS(M5x0.8x35mm)(37). The ROUND HEAD SCREWS(M5X0.8X35mm)(37) are already in the
RUBBER FEET(25). Attach the PLASTIC WHEELS(24) onto the FRONT FRAME(1) with WASHERS(M8)(46)
and NYLOCK NUTS(M8)(40).
STEP 3
Unfold your AeroPilates Performer 270 to a flat position by moving the FRONT FRAME(1) away from
the platform end of the product in a clockwise position until fully extended.
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please call
our toll-free number for assistance 1-800-375-7520 or e-mail us at customerservice@staminaproducts.com.