Filter
Top Products
HOW TO INSTALL AND REPLACE BATTERIES:
USING THE FITNESS MONITOR OR METER
Automatically scans each function of TIME, SPEED, DISTANCE, CALORIE, and PULSE in
sequence with change every four seconds. Press and release the MODE button until "SCAN"
appears on the display.
Displays the time from one second up to 99:59 minutes.
Displays the current speed from zero to 999.9 miles per hour.
Displays the distance from zero to 99.99 miles.
Displays calories burned from zero to 999.9 Kcal.
The Calorie Display estimates the average user's calorie consumption based on the speed
and time of the workout. The Calorie Display is not affected by the load adjustment. It should
be used only as a comparison between workouts on this unit.
Displays your heart rate in beats per minute. To display heart rate, press the MODE button to
select the PULSE mode. Use your forefinger to slightly touch the PULSE SENSOR on the
meter. The heart symbol "
" will begin flashing when the meter receives your heart rate
reading. Your heart rate will be displayed approximately five (5) seconds after the heart icon is
shown; however, if your finger isn't placed correctly on the PULSE SENSOR, you will not see
a heart rate on the display and the meter will cancel the heart rate circuit after 60 seconds. If
this occurs, press the MODE button to restart, place your finger back on the PULSE SENSOR
correctly and the heart rate readout will appear.
FUNCTIONS:
SCAN:
TIME:
SPEED:
DISTANCE:
CALORIE:
PULSE:
The meter will shut off automatically after four minutes of inactivity. All function values will be
kept. Press the RESET button and hold it down for three seconds to reset all functions to zero.
NOTE:
OPERATIONAL INSTRUCTIONS
POWER ON:
POWER OFF:
Pedal movement or press any button.
Automatic shut off after 4 minutes of inactivity.
Resets all values to zero.
FUNCTION BUTTONS:
/ UP:
/ DOWN:
MODE :
RESET :
Press to increase the level of the workload in
anytime during workout.
Press to decrease the level of the workload in
anytime during workout.
Press and release to select each function for
display.
This button will reset each function to zero.
To reset all functions to zero, press the button
and hold it down for three seconds.
Open the Battery Door on the back of the meter.
The meter operates with four AA batteries (four batteries included).
Refer to the illustration to install or replace the batteries.
1.
2.
Do not mix a new battery with an old battery.
Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
Rechargeable batteries are not recommended.
1.
2.
3.
NOTE:
14
AA Batteries
AA Batteries
Pulse Sensor