Filter
Top Products
SET UP INSTRUCTIONS
12
Place the Air Cross Trainer 1725 Elliptical in the area where it will be used. It is recommended that the Air
Cross Trainer 1725 Elliptical be placed on an equipment mat. The maximum operation dimensions of the
Air Cross Trainer 1725 Elliptical are approximately 41 1/2 inches long x 21 1/4 inches wide x 57 3/4 inches
tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe
operation of the Air Cross Trainer 1725 Elliptical. Make sure that adequate space is available for access
to and passage around the Air Cross Trainer 1725 Elliptical.
Adjust the LEVELING CAPS(63) on the REAR STABILIZER(3) so that the Air Cross Trainer
1725 Elliptical sits on the floor without rocking. Remove and reposition the LEVELING CAPS(63)
on the REAR STABILIZER(3) to level the Air Cross Trainer 1725 Elliptical.
Grasp the pivot tubes on the HANDLEBARS(7, 8) and REAR STABILIZER(3) to move the Air
Cross Trainer 1725 Elliptical, two people are required for moving. Do not use the PEDAL
ARMS(4, 5) to move the Air Cross Trainer 1725 Elliptical. The PEDAL ARMS(4, 5) will move
and may pinch your hand or fingers.
LEVELING:
MOVING:
FUNCTION INSPECTION:
Visually inspect the Air Cross Trainer 1725 Elliptical to verify that assembly is as shown in the above
illustration. Check the function of the Air Cross Trainer 1725 Elliptical, stand on the foot pedals and place
your hands at a comfortable position on the handlebars. Slowly move your highest foot forward and follow
the natural path of the machine. Complete one full revolution slowly to verify that the drive train functions
properly. Press the UP and DOWN buttons on the METER(33) to verify that the adjustable tension is working
properly.
Locate and read the WARNING LABEL(92) on the Air Cross Trainer 1725 Elliptical. Make
sure that all users read the WARNING LABEL(92).
Equipment Mat (not included)
CAUTION:
Grasp here to move
Grasp here to move