BUTTONS AND THEIR FUNCTIONS
The Sportline 345 Pedometer has 3 buttons for operating and programming: MODE/
RESET (located on the front of the unit below the display) and on the back panel of
the unit, the SET and the + (Adjust/increase) buttons.
MODE/RESET (MODE) BUTTON
• Operating Mode: Scrolls through display modes.
• Press & Hold: Resets pedometer data
• Programming Mode: Adjusts (decreases) information being adjusted.
SET BUTTON
• Operating Mode: Press & Hold to enter the Programming Sequence.
• Programming Mode: Accepts the information being adjusted and advances to the
next setting.
+ (ADJUST/INCREASE) BUTTON
• Programming Mode: Adjusts (increases) information being adjusted.
2- REMOVING BATTERY INSULATOR TAB 3- BUTTONS AND THEIR FUNCTIONS
1- INTRODUCTION
Back cover
345 PEDOMETER
USER GUIDE
/INSTRUCTION MANUAL
Congratulations on your purchase of a Sportline 345 Pedometer. The 345 Pedometer
features a highly advanced pedometer technology that accurately measures your
body movements when worn from multiple locations on the body and in multiple
orientations.
Please keep in mind your pedometer is a sensitive technical instrument. With
proper care and maintenance, it will last for many years. However, improper
care and handling can cause the various sensors to be damaged and to stop
functioning.
HOW TO USE THIS MANUAL
Please read all sections of this manual carefully and become fully familiar with
the operation of the pedometer before using it in the fi eld. Proper setup and
operation will greatly enhance the pedometer’s usefulness and your enjoyment.
The steps for the programming or operation are adjacent to the screen illustration.
Key points and important information are shown in highlighted blocks.
CUSTOMER SUPPORT
If you have questions, comments or need assistance with your Sportline
Pedometer, you may contact Customer Support by calling 1-866-694-4575.
NOTE: In order to activate your pedometer after purchase, you must remove the
battery insulator tab inside the battery compartment.
1. Locate the tab on the back of the pedometer.
2. Firmly grasp the tab and pull away from the pedometer until completely
removed from the unit.
3. Remove the label that appears on the pedometer display.
1 2
345 PEDOMETER
www.sportline.com
www.sportline.com
Walking Advantage by Sportline
TM
is distributed for EB Sport Group,
Yonkers, NY. in Canada by / Walking Advantage par Sportline
TM
est distribué pour EB Sport Group, au Canada par ACI Brands Inc,
2616 Sheridan Drive, Oakville, Ontario L6J-7Z2.
All Rights Reserved/Touts droits reservé ©2012
WV1056IS02SCC
Fold 1
Fold 2Fold 3 Fold 3
5- PROGRAMMING THE PEDOMETER
4. Adjust Height by PRESSING the + or - buttons. PRESS the SET button to accept
value.
5. This pedometer has an automatic stride length calculator that sets your length
based on your height. PRESS the SET button to accept this value or you can
adjust your Stride Length (see “Determining Stride Length” on the opposite
page) by PRESSING the + or MODE buttons.
6. PRESS the SET button. The unit is now programmed and ready for use!
4 5 6
4- PROGRAMMING THE PEDOMETER
In order to ensure exercise data is as accurate as possible, you must complete the
following steps to enter your personal profi le. The display will prompt you what
information is being programmed. Adjust information by PRESSING + (to increase)
OR MODE/RESET (MODE) (to decrease). Accept value and advance to the next setting
by PRESSING SET.
1. Enter the Programming Sequence by PRESSING & HOLDING the SET button on
the back of the unit for approximately 3 seconds.
2. Select unit of measure (metric or imperial) by PRESSING the + or MODE buttons
on the back of the unit. PRESS the SET button again.
3. Adjust Weight (in pounds or kilograms) by PRESSING the + (to increase) or MODE
(to decrease) buttons. PRESS the SET button to accept value and advance to set
Height.
1 12 2 33
To adjust value:
PRESS + or MODE/RESET
To accept and advance:
PRESS SET
To adjust value:
PRESS + or MODE/RESET
To accept and advance:
PRESS SET
Scroll through display
modes:
PRESS MODE/RESET
6- OPERATING THE PEDOMETER 7- RESETTING PEDOMETER DATA
The 345 Pedometer automatically begins capturing data once movement
occurs. There are no Start or Stop buttons to push.
Scroll through display modes: STEPS, DISTANCE, CALORIES AND EXERCISE TIME
by PRESSING THE MODE/RESET BUTTON.
TO CLEAR ALL CURRENT PEDOMETER DATA:
1. PRESS & HOLD the MODE/RESET button on the front of the unit.
2. Continue holding as the display reads “RESET”.
3. When pedometer data reads zeros (O), RELEASE THE MODE/RESET button.
The unit is now ready for a new workout.
NOTE: Your personal profi le settings will be saved.
STEPS
EXERCISE TIME CALORIES
DISTANCE
WV1056IS02SCC
9/11 /1 2
Ron