Filter
Top Products
XU875 & XR895
9
STEP 2: CONSOLE MAST ASSEMBLY
1. Install the Console Mast Cover (31) onto the console mast (2). Make sure the plastic cover is in
the correct orientation.
2. Connect the Upper Computer Cable (44) from the console mast to the lower Computer Cable
(45) and Speed Sensor Cable (46) from the receiving tube in the main body of the bike.
3. Install the Console Mast (2) into the receiving tube (make sure not to pinch the wire cables
(44,45,46). Damage to the electronics could occur) of the Main Frame with the 6pcs of
5/16x15mm Hex Head Screws (68), 4pcs of 5/16 x 19 x 1.5T Flat Washers (76) on the sides
and 2pcs of 5/16x20 x 1.5T Curved Washers (83) on the front by using the 12/14mm Wrench
(112).
4. Install the Upper Computer Cable (44) into the connector in the back of the Console (19). Install
the console onto the mounting plate with the 4pcs of M5x12mm Phillips Head Screws (99) by
using the Phillips Head Screw Driver (114).
5. Install the Handle Bar (3) onto the Console Mast (2) with the 2pcs of 5/16 x 15mm Hex Head
Bolts (68), 2pcs of 5/16 x 20 x 1.5T Flat Washers (83) and 2pcs of
8m/m x1.5T
Split Washers
(82) by using the 12/14mm Wrench (112).