Spirit XT475 Treadmill User Manual


 
XT375 / XT475 / XT675
15
!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE
READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from
unfolding accidentally during shipping. If this strap is not removed properly the treadmill could
spring open unexpectedly and cause injury if someone is standing near the treadmill when
the strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the
treadmill is positioned flat on the ground, in the orientation it would be in if you were using the
treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This could
cause the treadmills folding mechanism to spring open. If the end of the Velcro strap (that you
need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab
it, but do not tilt the treadmill up to gain access to the strap end.
Assembly (XT675)
Unpack the XT800 and locate the hardware pack. The hardware pack is separated into: one
section containing tools and four sections labeled steps 1- 4 which contain the hardware needed
for assembly of each step. The assembly steps below are numbered one through four and
correspond to the hardware in the numbered sections of the hardware pack. Remove only the
hardware for the step you are currently assembling to avoid confusion and mix-ups.
STEP 1
1 Take the Right upright tube and connect the Middle Console Cable that exits from the
bottom of the tube, with the lower Console Cable. Install the Left and Right (L & R)
Uprights into the Left and Right Receiving Tubes. Be careful not to pinch the wire
when installing the upright.
2. Install and hand tighten the two 3/8 x 2 Button Head Socket bolts, two 3/8 split washers
and two10 m/m Beveled Washers into the top holes on the front sides of the L & R tubes.
Then install and hand tighten the 6pcs of 5/16x 15mm Button Head Socket Screw in the
remaining holes on the sides and front of the L & R tubes. Do not tighten these screws
until assembly is complete. This makes aligning the holes for mounting the
console easier.