Filter
Top Products
XE Series Elliptical
11
STEP 3: HANDLE BAR ASSEMBLY
1. Remove the hardware from the hardware pack for step 3. You should have two 3/8 x 3/4
bolts (76), two large flat washers (131) and two large wave washers (102). Also locate the
two plastic end caps (33) from the tool section of the hardware pack.
2. Locate and install the two large wave washers (102) onto the handle bar axle, one on
each side.
3. Slide the left and right handle bars onto the appropriate side of the axle. There is a sticker
on each handle bar indicating L for left and R for right. The left and right sides of the
elliptical are determined as if standing on and using the elliptical.
4. Put the plastic end caps (33) and the two flat washers (131) onto the two 3/8 x 5/8 bolts
(76), then install and tighten into the threaded holes in the ends of the axle.
5.