Filter
Top Products
6
Elliptical T
rainer
XE295
1. Slide two Wave Washers (81) onto both the Left and Right Console Mast axle.
2. Slide the Swing Arms (L) and (R), (10 & 11) onto the appropriate side of the axle. Note: Make sure the arms are
attached as shown in the illustration.
3. Place a Flat Washer (97) onto each Hex Head Bolt (103) and fasten in the end of the left and right axle.
Tighten with the wrench (106).
4. Slide the grommet (123) onto the Resistance cable (124); connect the two Resistance cables (124 & 125)
and store the excess cable in the Console Mast tube (12) after snapping the grommet into the hole of the
console mast tube.
HARDWARE
STEP 2: Swing Arms
#97.3/8” x 30mm
Flat Washer
(2 pcs)
#81. 25mm
Wave Washer
(4 pcs)
#103.3/8” x 3/4”
Hex Head Bolt
(2 pcs)
#123.Grommet
(1 pc)