Spirit ET8 Treadmill User Manual


 
ET6 / ET8 / ET10
11
Assembly ( ET10 )
STEP 1
Remove all parts from the carton.
STEP 2
Connect the lower Computer Cable with the upper Computer Cable.
STEP 3
Hand tighten Right and Left Uprights into Main Frame with two 3/8 x 2 Button Head Socket Bolts, two
3/8 x 2T Split Washers and six 5/16 x 1/2 Button Head Socket Bolts by using the
Combination M5
Allen Wrench & Phillips Head Screwdriver and M6 Allen Wrench.
STEP 4
Install the Upright Support onto the Left and Right Uprights with four 5/16 x 3/4 Button Head Socket
Bolts, by using the Combination M5 Allen Wrench & Phillips Head Screwdriver.
STEP 5
Connect the middle Computer Cable with the upper Computer cable from the console.
Connect the Speed Switch Cable with the upper Speed Cable from the console.
Connect the Incline Switch Cable with the upper Incline Cable from the console.
STEP 6
Install the Console Support into the Right and Left Uprights with four 5/16 x 1/2 Button Head Socket
Bolts, by using the Combination M5 Allen Wrench & Phillips Head Screwdriver. Then Install the
Beverage Holder onto the Console Support. * Tighten all screws installed in STEP 4.
STEP 7
Install the four speed Nuts into side of the Top Motor Cover.
STEP 8
Install Frame Base Cap (R) and Frame Base Cap (L) with two 5 x 16 m/m Tapping Screws and four 5 x
16 m/m Tapping Screws by using the Combination M5 Allen Wrench & Phillips Head Screwdriver.
PLEASE LOCK DOWN ALL HARDWARE AFTER THE ACCESSSORIES HAVE BEEN
ASSEMBLED.