Spirit EL255 Elliptical Trainer User Manual


 
EL255 Elliptical
8
STEP 1: CONSOLE MAST ASSEMBLY
Locate the Console Mast (10) and Console Mast Cover (41) and slide the Cover onto the Mast as
far as it will go. Make sure the Console Mast Cover is facing the correct way.
At the top opening of the Main Frame (1) there is a Computer Cable (32) attached to a guiding wire.
Unravel the wire and feed the Computer Cable into the bottom of the Console Mast tube and out of
the top opening.
Install the Console Mast (10) into the receiving bracket on the top of the Main Frame. Pull slightly on
the computer cable at the top of the mast while installing, this will ensure the cable does not get
pinched and shorted during mast assembly.
Install one 3/8" Split Washer (120) and one 3/8 Curved Washer (114) onto one of the 3/8" x 3" Hex
Head Bolts (119) and install through the front of the Console Mast; just hand tighten for now. Install
two 3/8 Flat Washers (94) and two 3/8" Split Washers (120) onto two 3/8" x 3" Hex Head Bolts
(119). Install them through the left side of the receiving bracket into the Console Mast. Now tighten
all 3 bolts as tight as possible and snap the console mast cover into place.
There are three connectors at the top opening of the Console Mast; two Hand pulse wires (37) and
one Computer Cable (32). Connect these to the mating connectors on the back of the Console
Assembly (31). Store the excess wiring back into the Console Mast (10) as you carefully install the
Console Assembly (31) onto the mounting plate of Console Mast. Secure the console with four M5
Phillips Head Screws (78).