Spirit EL255 Elliptical Trainer User Manual


 
EL255 Elliptical
10
STEP 3: CONNECTING ARMS AND REAR RAIL ASSEMBLY
Align the hole in the rod end bearings at the ends of the Connecting Arms (7&8) with the hole in
the bracket of the Swing Arms. There is a sleeve spacer already installed in the rod ends and
held in place with a twist tie; make sure these spacers do not fall out during assembly. The rod
end bearing should be positioned to the inside of the swing arm brackets. Install two 5/16" Hex
Head Bolts (71) through the left and right swing arm brackets and the rod end and secure with
5/16" Flat Washers (98) and 5/16" Nuts (105).
Install the two Rear Rail Tubes (16) to the rear end of the Main Frame (1) and secure with two
3/8 x 2-1/4 Bolts (76), two 3/8 Flat Washers (94) and two 3/8 Nuts (89).
Install the Rail Stabilizer (15) between the rearward ends of the Rail Tubes (16) and secure with
four 3/8 x 2-1/4 Bolts (76) and 3/8 Curved Washers (114).