Filter
Top Products
EL1 Elliptical
13
The elliptical is equipped with two transport wheels that are engaged when the rear of the
Elliptical is lifted.
Getting familiar with the control panel
Power up
The Elliptical is supplied with an external power supply. When power is connected to the Elliptical,
the console will automatically power up. If there is no input to the console for 20 minutes the
console will go to stand-by mode. In stand-by mode the console display will turn off. To turn the
console on press any key.
When initially powered on the console will perform an internal self-test. During this time all the
lights will turn on. When the lights go off the dot matrix display will show a software version (i.e.:
VER 1.0) and the message window will display an odometer reading. The odometer reading
displays how many hours the elliptical has been used and how many virtual miles the elliptical has
gone. The time in hours will be to the left and the odometer in miles will be displayed to the right.
The odometer will remain displayed for only a few seconds, then the console will go to the start up
display. The dot matrix display will be scrolling through the different workout profiles of the
programs and the message window will be scrolling the start up message. You may now begin to
use the console.
Operation of Your Elliptical
Transportation