Filter
Top Products
sizing straps provided to fit different
diameter bars. (See figure 3) Slide the
computer forward onto the mounting
until it ‘snaps’ into place with an audi-
ble click. To remove the computer, push
it backward until it releases from the
mount. To test for proper installation of
the magnet, sensor and computer, acti-
vate the computer by picking up the
front of the bicycle and spinning the
wheel. The "wheel" (1) indicator will
flash. If it does not flash check the sen-
sor and magnet alignment. Realign as
necessary until the "wheel" indicator
flashes while spinning the wheel.
PROGRAMMING
Programming the functions of your
SpeedZone Sport requires it to be
placed in various "modes" (i.e.
odometer mode, stopwatch mode).
The computer can be cycled through
these modes by pressing the "MODE"
button located on the right-hand side
of the housing. Once a specific mode
has been entered, its values can be
reset or adjusted by pressing the
"FUNCTION" button located on the
left-hand side of the housing.
1. Miles or Kilometers selection
Your SpeedZone Sport will record
speed and distance in either miles (M)
or kilometers (KM). To select miles or
kilometers, push the "MODE" button
until ODO (odometer) appears in the
lower left side of the display (This is
called the odometer mode). Hold down
the "FUNCTION" (left side) button and
‘tap’ the "MODE" button once. The
KM, M indicator will begin blinking.
You may now alternate between miles
4