Filter
Top Products
2. Setting the Programmable
Odometer
This mode is useful if you have
replaced the battery and would like to
retain the mileage you have already
ridden. To access the programmable
odometer mode, first advance the
"MODE" button until (ODO) appears
on the left-hand side of the screen.
Hold down the "FUNCTION" button
and ‘tap’ the "MODE" button once.
The Km/h indicator will flash. If the
Km/h setting is correct press the
"FUNCTION" button once and a five-
digit number will appear. You are now
in the programmable odometer mode.
To enter a mileage into the odometer,
press the "MODE" button until the
flashing digit is correct.
(Note: The "MODE" button may be
held to scroll to the correct digit.) Press
the "FUNCTION" button to select the
next digit to the right. Repeat this
process until all five digits are entered
as your existing mileage.
3. Wheel Circumference Selection
To set the circumference for the type of
tires you are using, you can use
Specialized’s "Easy Calibration Mode"
or measure your actual tire circumfer-
ence by the rollout method. Two dif-
ferent tire diameters may be entered
by using the computer’s "Second
Wheel Option."
7
PROGRAMMING
Programming the functions of your
SpeedZone
®
Elite requires it to be
placed in various "modes" (i.e.
odometer mode, distance mode). The
computer can be cycled through these
modes by pressing the "MODE" button
located on the right-hand side of the
housing. Once a specific mode has
been entered, its values can be reset
or adjusted by pressing either the
"FUNCTION" button located on the left
hand side of the housing or by using a
combination of the "MODE" and
"FUNCTION" buttons.
1. Miles or Kilometers selection
Your SpeedZone
®
Elite will record
speed and distance in either miles
(M/h) or kilometers (Km/h). To enter
your selection of miles or kilometers,
push the "MODE" button until ODO
(odometer) appears on the left side of
the display (This is called the odometer
mode). Hold down the "FUNCTION"
(left side) button and ‘tap’ the "MODE"
button once. The Km/h, m/h indicator
will begin blinking. You may now alter-
nate between miles and kilometers by
pressing the "MODE" button. When
the correct choice is flashing, select it
by pressing the "FUNCTION" button.
You will now enter the "Programmable
Odometer" mode. If the odometer set-
ting is correct push the "FUNCTION"
button five times to exit odometer
mode. (Otherwise, see "Setting the
programmable odometer" below).
6
01_SDZN_ELITE_USA_1-22.qxd 4/18/01 8:32 PM Page 6