Filter
Top Products
Average Speed (AVS)
The average speed is displayed
on the lower line of the screen when
AVS is shown on the left. The average
speed is based upon whether the ATM
or the TM mode has been selected,
the resolution of the average speed is
shown in 0.1M/h or Km/h increments.
(See figure 11)
+/- Average Speed Indicator
An up or down arrow displayed in
the upper right side of the screen
shows whether the current speed is
above or below the average speed.
The arrow is always displayed so you
know if you’re maintaining your aver-
age speed while in another mode.
Maximum Speed (MXS)
The maximum speed is displayed on
the lower line of the screen when MXS
is shown on the left. The maximum
speed is retained in memory and up-
dated when a higher speed is attained.
The maximum speed can be reset by
pressing the "FUNCTION" button for
three seconds. (See figure 12)
13
timer mode, press the "MODE" button
until the hourglass appears on the left-
hand side of the screen. You are now
in interval timer mode. To set the inter-
val timer, hold the "FUNCTION" button
for three seconds. The hour digit will
begin flashing. Press the "MODE"
Button until the desired number
appears. Press the "FUNCTION" but-
ton once to set this number and
advance to minutes. Repeat this
process until minutes and seconds are
set to the desired settings. Press the
"FUNCTION" button to exit program-
ming mode. Once the interval timer is
programmed, press the "FUNCTION"
button to start/stop the countdown.
(See figure 10)
Note: The shortest interval that can
be set is 5 seconds.
COMPUTER FUNCTIONS
Speedometer
Speed is always indicated on the top
line of the screen. The speed is shown
continuously up to 99.9 M/h (99.9
Km/h) with a resolution of 0.1 M/h
(0.1 Km/h)
12
FIGURE 10: INTERVAL TIMER SCREEN FIGURE 11: AVERAGE SPEED SCREEN
01_SpeedZone_COMP_USA.qxd 4/21/01 3:33 AM Page 12