Filter
Top Products
10
P/N M601111 08/05
Align dimple of middle pole with slot of bottom pole.While maintaining alignment, bounce
top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no
longer move toward pole identification mark.
3.
WOOD SCRAP
(NOT SUPPLIED)
POLE
IDENTIFICATION
MARK
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-1/2"
BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!
2
3
1
B
ottom Pole
IDENTIFICATION
STICKER
Bottom Pole
IDENTIFICATION
STICKER
5"
1-1/2"
Holes in top (1) and bottom (3)
pole sections MUST align to
correctly position elevator
system toward playing
surface.
IMPORTANT!
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM)
MINIMUM
OVERLAP.
NOTE: