Filter
Top Products
02/07 ID# M6711041
13
6
5
4
3.
WOOD SCRAP
(NOT SUPPLIED)
5
4
While maintaining alignment, bounce middle pole section (5) into top section (4) using a wood scrap as
shown until the top pole no longer moves toward the pole identification sticker on the middle pole.
Identification Sticker
Align dimple of top pole section (4) into trough of
middle pole section (5) as shown.
IMPORTANT!
HOLE
DIMPLE
middle pole
5"
middle pole
1-1/2"
2.
Identify pole sections.
ID
STICKER
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE
POLE SECTIONS SHOULD HAVE
A 3-1/2" MINIMUM OVERLAP,
LEAVING 1-1/2" BETWEEN THE
OVERLAPPING POLE AND THE
IDENTIFICATION STICKER.
CAUTION!