Filter
Top Products
24 9.35HR TREADMILL
ASSEMBLY
STEP 7: ATTACH ADJUSTABLE CYLINDER TO TREADMILL FRAME
WARNING: THE PATENTED HYDRASUSPENSION SYSTEM REQUIRES THE
ADJUSTABLE CYLINDER TO BE TIGHT FITTING. PLEASE BE
PATIENT WITH THIS ASSEMBLY STEP.
(A) Put Adjustable Cylinder Cover-Upper (315) into Adjustable Cylinder (310).
(B) Attach the bottom of the Adjustable Cylinder (310) to the left Cylinder Mounting
Shaft (509) and secure with 8x23x2mm washer (846) and one M8 Nylon Nut (826).
(C) Attach the head of the Adjustable Cylinder (310) to the left upright (301):
a: Align the through hole on the head of the Adjustable Cylinder (310) with the
mounting hole on the frame (301).
b: As you slide the threaded shaft (845) through the aligned holes .
(D) Secure the cylinder head with two M8x15mm Allen Head Bolts (843).
(E) Repeat this procedure to assemble the Adjustable Cylinder on the right side of the
frame.
826
X2
843
X4
845
X2
846
X2