Filter
Top Products
English
34
English
35
HAND POSITION ADJUSTMENT
(mode indicator, center hand, hands of the small watch)
u
Hand position adjustment is a procedure required when the hands are not
correctly aligned for use in the STOPWATCH or TIMER functions, or after
the battery is changed or the built-in IC is reset. For example, when the
hands are not pointing to the 0 position even after the stopwatch is reset.
After hand position adjustment is carried out, it is necessary to set the
time.
Pull out to second click.
The small second hand will stop on
the spot.
* If the crown is pulled out while the timer
or stopwatch is measuring time, the
measurement will be forcibly terminated
and the timer or the stopwatch will be
reset.
l
How to adjust the positions of the mode indicator, center
hand and the hands of the small watch
MODE SELECT
T
I
M
E
5
6
1
0
T
M
R
C
H
R
A
L
M
L
O
C
CROWN
A
B
CROWN
NECESSARY PROCEDURE AFTER BATTERY
CHANGE
After the battery is replaced with a new one, or when an abnormal display appears,
follow the procedures below to reset the built-in IC. The watch will resume its
normal operation.
l
HOW TO RESET THE IC
1. Pull out the crown to the second click.
2. Press button A and B at the same time.
3. Push the crown back in to normal position and check if the hands move as
normal.
* Resetting the IC will initialize the watch. Before starting to use the watch, it will be necessary to
set the time and adjust the STOPWATCH hands to the 0 position.
Refer to HAND POSITION ADJUSTMENT and TIME MODE sections of this manual.
7T84_E.indd 34-35 07.5.25 11:42:41 AM