Filter
Top Products
11
11
12
13
11. Identify the Right Handlebar (20), which is
marked with a “Right” sticker, and orient it as
shown.
Attach the Right Handlebar (20) to the Upright
(2) with two M8 x 16mm Screws (69).
Attach the Left Handlebar (7) in the same
way.
12. Identify and orient the Rear Upright Cover (57)
as shown.
Attach the Rear Upright Cover (57) to the Upright
(2) with an M4 x 16mm Screw (77).
7
20
77
57
2
2
2
69
69
13. Untie and discard the wire ties on the Main
Wire (43), the Frame Pulse Wire (42), and the
Receiver Wire (40).
While a second person holds the Console (4)
near the Upright (2), connect the wires on the
Console to the Main Wire (43), to the Frame
Pulse Wire (42), and to the Receiver Wire (40).
Insert the excess wires into the Upright (2) or
into the Console (4).
Tip: Start all the screws before tightening
any of them. Also, avoid pinching the wires.
Attach the Console (4) to the Upright (2) with
four M4 x 16mm Screws (77).
4
77
43
42
40
Avoid pinching
the wires