Filter
Top Products
C.
If the walking belt is overtightened, treadmill performance
may decrease and the walking belt may be permanently
damaged. Remove the safety key and UNPLUG THE
POWER CORD. Using the allen wrench, turn both rear
roller adjustment bolts counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you should
be able to lift each side of the walking belt 3-4 inches off
the walking platform. The center of the walking belt
should be just above the walking platform. Be careful to
keep the walking belt centered. Plug in the power cord,
insert the safety key and run the treadmill for a few min-
utes. Repeat until the walking belt is properly tightened.
Rear Roller Adjustment Bolts
5. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a.
If the walking belt has shifted to the left, first remove the
safety key and UNPLUG THE POWER CORD. Using
the allen wrench, turn the left rear roller adjustment bolt
clockwise, and the right bolt counterclockwise, 1/4 of a
turn each. Be careful not to overtighten the walking belt.
Plug in the power cord, insert the safety key and run the
treadmill for a few minutes. Repeat until the walking belt
is centered.
b.
If the walking belt has shifted to the right, first remove the
safety key and UNPLUG THE POWER CORD. Using
the allen wrench, turn the left rear roller adjustment bolt
counterclockwise, and the right bolt clockwise, 1/4 of a
turn each. Be careful not to overtighten the walking belt.
Plug in the power cord, insert the safety key and run the
treadmill for a few minutes. Repeat until the walking belt
is centered.
C°
If the walking belt slips when walked on, first remove the
safety key and UNPLUG THE POWER CORD. Using
the allen wrench, turn both rear roller adjustment bolts
clockwise, 1/4 of a turn. When the walking belt is correctly
tightened, you should be able to lift each side of the walk-
ing belt 3-4 inches off the walking platform. The center of
the walking belt should be just above the walking plat-
form. Be careful to keep the walking belt centered. Plug in
the power cord, insert the safety key and run the treadmill
for a few minutes. Repeat until the walking belt is properly
tightened.
STORAGE
Unplug the power cord when the treadmill is not in use. Remove the bolt and washer from the lower
end of the handrail. Loosen the nut at the upper end of the handrail. Loosen the lock knob at the front
of the upright. Carefully lay the upright on the treadmill. Keep the hardware in a secure location. It is
recommended that the treadmill be covered during extended periods of storage.
_11.....