Filter
Top Products
ASSEMBLY
4
2
5
14
1
30
18
Square Holes
2
1
32
2. Align the Front Stabilizer (5) with the saddle bracket
on the front of the Frame (1). Make sure that the
Front Stabilizer is turned so the square holes
are facing away from the saddle bracket. Attach
the Front Stabilizer with two Stabilizer Carriage
Bolts (18), two Curved Washers (14), and two
Stabilizer Nuts (30).
3
40
37
36
38
1
38
33
33
41
3
42
Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Assembly requires a phillips screwdriver
and an adjustable wrench (not included).
1. Refer to the inset drawing. Remove the indicated
plastic cap from the Frame (1). Discard the cap.
Next, slide the bracket on the Rear Stabilizer (2)
into the Frame (1). Attach the Rear Stabilizer with
four Stabilizer Screws (32).
3. Refer to the inset drawing. Remove the indicated
plastic caps from the Frame (1). Discard the caps.
Next, slide the Left Handlebar (40) into the left side
of the Frame (1). Slide the Right Handlebar (41) into
the right side of the Frame.
Slide the Foam Grip (42) onto the Top Handlebar (3).
Push the ends of the Foam Grip towards the center
of the Top Handlebar so the ends of the Top
Handlebar are uncovered. Insert the Top Handlebar
into the Left and Right Handlebars (40, 41) and
attach it with two Handlebar Screws (33). Slide the
Foam Grip back so it covers the Handlebar Screws.
Align the holes in the Left and Right Handlebars
(40, 41) with the holes in the Frame (1). Attach the
Handlebars with four Handlebar Bolts (36), four
Handlebar Washers (38), and four Locknuts (37).
Make sure that the Locknuts are in the hexagonal
holes in the Frame.
1
1
Cap
1
Caps