Filter
Top Products
6
7
45
45
2
21
49
10
7
11
17
5
5
6
51
56
36
Hole
1
4
51
5. Push the Magnet Bracket (36) into the hole in the
Pedal Frame (4).
Lubricate an M8 x 157mm Axle (13). Attach the
Pedal Frame (4) to the Main Frame (1) with the M8
x 157mm Axle, two Rubber Washers (51), and two
M8 Acorn Nuts (56).
6. Attach the Left Side Shield (21) to the Seat Frame
(2) using three Tree Fasteners (45). If you can’t
push the Tree Fasteners in with your fingers, tap
them in with a rubber mallet.
Attach the Right Side Shield (22, not shown) in the
same way.
7. While another person holds the Long Link Arm (10)
and the Short Link Arm (11) in place, put two Plastic
Washers (49) between them. Then, connect the
Seat Swing Arm (5), the Long Link Arm (10), and
the Short Link Arm (11) using an M8 x 1.375” Bolt
(17) and an M8 Nylon Jam Nut (7).
8. Remove the 1” x 2” Endcap (50) from the Seat
Frame (2). Slide the Weight Saddle (8) onto the
Seat Frame (2). Hook the tab on the Weight Saddle
(8) into the indicated hole in the Seat Frame (2).
Place the Seat (20) on the Weight Saddle (8). Slide
the Seat Washer (38) onto the Seat Knob Bolt (43)
and then tighten the Seat Knob (37) onto it.
8
2
Tab
Hole
20
43
50
38
37
8
Lubricate—13
56