Filter
Top Products
9. Hold one of the Pedal Shafts (38) with the included tool as shown---the tool must be between the coils of the
Pedal Spdng (52). Using an adjustable wrenoh, remove the 1/2" Nylon Lock Nut (46) f_n"tll_ end of the Peda
Shaft. (There is an 11116" Spdng Washer (51), a Pedal Spring (52), an 11/16" Washer 154), a Pedal Bushing
155), a 9/'16" Washer (56) and a 9/16" Pedal Spacer (75) on the Pedal Shaft.) Using the included tool, _rmty :t__.._T,_
tighten the Pedal Shaft, In a clockwise direction, into one of the arms of the Crank 127). While holding the Pedal
Shaft with the tool, use an adjustable wrench to tighten the 1/'2" Nylon Lock Nut (46) onto the end of the Pedal
Shaft. (There is a 5/16" Washer (65) and a 5/16" Pedal Nut (49) on the other end of the Pedal Shaft. The 5116"
Pedal Nut (49) must be flush with the end of the Pedal Shaft.) Press a Pedal Cap (50) into the Pedal (10).
Attach the other Pedal Shaft to the other arm of the Crank in the same manner (not shown).
9
) 49
52 Tool
55 66 . 75
7