Filter
Top Products
2. Slide the Front Upright (42) onto the 5/16” x
2 1/2” Carriage Bolts (1) in the Base (4). Hand
tighten a 5/16” Nylon Locknut (3) onto each
Carriage Bolt. Do not tighten the Nylon
Locknuts yet.
Press a 1” Square Inner Cap (65) into the
Front Upright (42).
Press 1” Round Inner Cap (49) into each end
of the Footrest (83). Attach the Footrest to the
Rear Upright (56) with a 5/16” x 2 3/4” Bolt
(11), two 5/16” Flat Washers (8), a 1/2” x 1/2”
Bushing (87), and a 5/16” Nylon Locknut (3).
3. Press a 2” Square Inner Cap (27) into the indi-
cated end of the Top Frame (55). Press a 1
3/4” Square Inner Cap (44) into each end of
the crossbar on the Top Frame. Press two 1”
Round Inner Caps (49) into the top of the
crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16”
x 2 3/4” Bolts (11), four 5/16” Flat Washers (8),
and four 5/16” Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 1
through 3.
4. Set two Weight Bumpers (19) on the indicated
bracket on the Base (4) as shown.
Stack eight Weights (25) on the Weight
Bumpers (19). Be sure that all of the
Weights are turned so the deepest pin
grooves are under the Weights and are on
the indicated side.
4
2
3
FRAME ASSEMBLY
6
49
49
3
3
8
83
87
8
11
56
1
4
11
65
42
11
44
27
3
3
44
42
Crossbar
4
19
25
Pin
Grooves
56
55
49
8
8