Filter
Top Products
21
TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The
home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the home
gym system, can stretch slightly when it is first used.
If there is slack in the cables before resistance is felt,
the cables should be tightened. Slack can be removed
from the cables by tightening the 1/4” Nylon Locknuts
(2) at the end of the Long Cable (23) (see drawing 1)
and at the end of the Short Cable (58) (see drawing
2). To do this you may need to remove the Small “U” -
Bracket (67) from the Weight Tube (63) or remove the
3 1/2” Pulley (15) from the Long “U”-Bracket (57).
Make sure that the cables are not too tight, or the Top
Weight (76) will be lifted off the weight stack.
Additional slack can be removed by moving the 3 1/2”
Pulley (15) to the other hole in the Long “U”-Bracket
(57). Remove the 3/8” Nylon Locknut (21) and the
3/8” x 2” Bolt (12) from the Cable Trap (66), Pulley,
and Long “U”-Bracket. Re-attach the Pulley and Cable
Trap. Be sure that the Cable trap is in the proper
position and that the Cable and Pulley move
smoothly.
If the cables need to be replaced, see the back cover
of this manual.
57
66
15
2
58
21
23
2
23
12
67
76
2
1